ForceField® De-Crease Wrinkle Remover

 

Section I  Product Identification

Product ID:  F DWR

Last Revision Date: 01/01/00

Preparer:  R. Lasnik, Vice President                                                                             

 

Section II   Hazardous Ingredients

Isopropyl Alcohol (CAS 67-63-0)

HMIS Rating:   Health-1     Flammability-0    Reactivity-0    PPE-B

 

Section III  Physical Data

Boiling Point: >212 0F

Water Solubility: Insoluble 

Specific Gravity:  1.00              Weight Per Gallon: 8.34 lbs.

Odor:  Mild Characteristic light Floral Fragrance

Appearance:  Clear Colorless Liquid

 

Section IV   Fire and Explosion Hazard Data

Hazardous Combustion Products: Oxides of Carbon & Nitrogen.

Flash Point:  N.A.

Extinguishing Media: Dry Chemical, Carbon Dioxide, Water Spray.

Special Fire Fighting Procedures: Evacuate personnel to a safe area.  Avoid breathing decomposition products.  Eliminate sources of ignition.

 

Section V Health Hazard Data

Primary Route(s) of Entry:         Inhalation: N     Ingestion: Y      Skin: Y      Eyes: Y
Effects of Acute Overexposure:

Eye:  Contact may cause eye irritation.

Skin:  Prolonged and repeated skin exposure may cause dry skin and be irritating to some people.

Ingestion: May cause mild discomfort, seek medical attention as needed.

Inhalation: Not known .  

 

Carcinogenicity Information: IARC, NTP, OSHA or ACGIH lists none of the components present in this material as a carcinogen.

First Aid Procedures:    Inhalation: Remove to fresh air. If not breathing, give artificial respiration. 

If breathing is difficult, give oxygen and call a physician.

Skin Contact: Remove contaminated clothing. Flush skin with soap & water.

Eye Contact: Flush eyes at least 15 minutes with fresh water, and seek medical

attention.

Ingestion:  Seek medical attention immediately.

F DWR DE-CREASE WRINKLE REMOVER

 

Section VI   Reactivity Data

Instability:  Stable

Incompatible Materials: None Known.

Hazardous Decomposition Products: Thermal decomposition and burning may produce Oxides of Carbon, or Nitrogen.

Hazardous Polymerization: None will occur.

 

Section VII   Spill or Leak Procedures

Spill, Leak, or Release: Contain spill and salvage as much material as possible.  Pick up the remaining with absorbent.

Waste Disposal: Dispose of only by methods approved by and used in accordance with local, state, and federal regulations.

 

Section VIII   Special Protection Information

Respiratory:  None required with normal ventilation.

Protective Gloves: Use rubber or plastic gloves to prevent prolonged contact.

Eye: Use safety eye wear where splashing is likely.

Protective Clothing: None required.

 

Section IX   Special Precautions

Storage: Store at room temperature.  Keep container tightly closed to prevent leakage or evaporation and keep away from heat.  Keep out of reach of children.

 

Section X   Regulatory Information

EPA Regulations: SARA Section 311/312 Hazards Categories: None

DOT Shipping Name:  Not Regulated.

TSCA Inventory Status: Mixture

 

Disclaimer:  As the handling and use of products under user’s conditions are beyond our control, no warranty, expressed or implied, including, but not limited to merchantability or fitness for a particular use, is made concerning this product.  The user assumes all risk of use or handling whether or not in accordance with any directions or suggestions of the supplier.  Seller shall not be liable to purchaser or any other person for loss or damages directly or indirectly arising from the use of our products, from breach of any warranty or from any other cause, the exclusive remedy against the seller being to require replacement or repair of defective goods.

 

TDS

Printable MS Word - MSDS (Click Here)

CORPORATE OFFICES
Shield Industries, Inc.
131 Smokehill Lane - Woodstock, GA 30188
(800) 332-6327 - (770) 517-6869 - Fax (770) 517-6863

Emergency Phone 1-800-535-5053

Email: info@shieldindustries.com
www.shieldindustries.com