ForceField^® UPHOLSTERY & FABRIC PROTECTOR

 

Section I  Product Identification

Product ID:  F FBP

Last Revision Date: 01/01/00

Preparer:  R. Lasnik, Vice President                                                                                 

Section II   Hazardous Ingredients

Synthetic Isoparaffinic Hydrocarbon (CAS 64742-48-9)

Perfluorinated Alkyl Copolymer (CAS None Assigned)

HMIS Rating:   Health-1     Flammability-2    Reactivity-0    PPE-B

Section III  Physical Data

Boiling Point: >212 ⁰F

Water Solubility: Insoluble 

Specific Gravity:  0.75               Weight Per Gallon: 6.26 lbs.

Odor:  Mild Petroleum

Appearance:  Clear Colorless Liquid

Section IV   Fire and Explosion Hazard Data

OSHA: Combustible Liquid

Flash Point:  106 ⁰F

Extinguishing Media: Dry Chemical, Carbon Dioxide, Water Spray, and Foam

Special Fire Fighting Procedures: Avoid breathing decomposition products.  Water fog nozzles may be used to cool fire-exposed containers.

Section V Health Hazard Data

Primary Route(s) of Entry:              Inhalation: Y             Ingestion: Y      Skin: Y      Eyes: Y

Effects of Acute Overexposure:

Eye:  May cause stinging of eyes followed by irritation.

Skin:  Prolonged and repeated skin exposure may be irritating to some people.

Ingestion: Effects are unknown. Seek medical attention as needed.

Inhalation: Over exposure can cause nasal and respiratory irritation.

Carcinogenicity Information: IARC, NTP, OSHA or ACGIH lists none of the components present in this material as a carcinogen.

First Aid Procedures:             Inhalation: Remove to fresh air.

Skin Contact: Flush skin with soap and water.

Eye Contact: Flush eyes at least 15 minutes with fresh water.

Ingestion:  Seek medical attention immediately.

F FBP  FORCEFIELD UPHOLSTERY & FABRIC PROTECTOR

Section VI   Reactivity Data

Instability:  Stable

Incompatible Materials: Avoid strong oxidizing agents.

Hazardous Decomposition Products: Thermal decomposition and burning may produce Oxides of Carbon, Nitrogen, or Fluorine.

Hazardous Polymerization: None will occur.

Section VII   Spill or Leak Procedures

Spill, Leak, or Release: Eliminate all ignition sources.  Contain spill and salvage as much material as possible.  Pick up the remaining with absorbent.

Waste Disposal: Dispose of only by methods approved by and used in accordance with local, state, and federal regulations.

Section VIII   Special Protection Information

Respiratory:  None required with normal ventilation.

Protective Gloves: Use rubber or plastic gloves to prevent prolonged contact.

Eye: Use safety eye wear where splashing is likely.

Protective Clothing: None required.

Section IX   Special Precautions

Storage: Do not store above 120⁰F.  Keep container tightly closed to prevent leakage or evaporation.  Keep out of reach of children.

Section X   Regulatory Information

EPA Regulations: SARA Section 311/312 Hazards Categories: None

DOT Shipping Name: Not Regulated in quantities less than 119 gallons when shipped by ground.

TSCA Inventory Status: Mixture

Disclaimer:  As the handling and use of products under user’s conditions are beyond our control, no warranty, expressed or implied, including, but not limited to merchantability or fitness for a particular use, is made concerning this product.  The user assumes all risk of use or handling whether or not in accordance with any directions or suggestions of the supplier.  Seller shall not be liable to purchaser or any other person for loss or damages directly or indirectly arising from the use of our products, from breach of any warranty or from any other cause, the exclusive remedy against the seller being to require replacement or repair of defective goods.

TDS

Printable MS Word - MSDS (Click Here)