ForceField® Restor-It – Cream Furniture Polish For
Fine Wood
Section I Product Identification
Product ID: F RST
Chemical Family: Aqueous Emulsion of Synthetic Oils
Last Revision Date:
04/01/02
Preparer: R.
Lasnik, Vice
President
Section II Hazardous Ingredients
This product
contains no hazardous ingredients as per OSHA Communication
Standard, CFR 1910.1200.
HMIS
Rating: Health-1 Flammability-0 Reactivity-0 PPE-X
Personal protection rating to be
supplied by the user depending upon use conditions.
Section III Physical Data
Boiling Point: 100 0C
pH: 7.5 to 10.5
Water Solubility: Emulsifiable
Specific Gravity:
1.00 +/- .02 Weight Per Gallon: 8.34 lbs.
Odor: Mild Lemon
Fragrance
OSHA: Not Regulated
Flash Point: >200
0F (PMCC)
Extinguishing
Media: Dry Chemical, Carbon Dioxide, Water Spray, and Foam
Special
Fire Fighting Procedures: Evacuate personnel to a safe area.
Avoid breathing decomposition products. Fire fighting
personnel should wear respiratory protection.
Unusual
Hazards: None
Section V Health Hazard Data
Primary Route(s) of Entry: Inhalation: N
Ingestion: Y Skin: Y Eyes: Y
Effects of Acute Overexposure:
Eye: May cause mild stinging of eyes
followed by irritation.
Skin: Prolonged and repeated skin
exposure may be irritating to some people.
Ingestion: Effects are unknown. Seek
medical attention as needed.
Inhalation: Over exposure can cause
nasal and respiratory irritation.
Carcinogenicity Information: IARC, NTP, OSHA or ACGIH lists
none of the components present in this material as a
carcinogen.
First
Aid Procedures:
Inhalation: Remove to fresh air. If not breathing, give
artificial respiration.
If breathing is difficult, or
respirator tract is irritated, consult a physician.
Skin
Contact: Remove contaminated clothing. Flush skin with soap
and water.
Eye Contact: Flush eyes at least 15
minutes with fresh water.
Ingestion: Effects of Ingestion are
unknown. Seek medical attention immediately.
F RST
RESTOR-IT – CREAM FURNITURE POLISH
Section VI Reactivity Data
Instability:
Stable
Incompatible
Materials: None Known
Hazardous
Decomposition Products: Thermal decomposition and burning may
produce Oxides of Carbon and Sulfur.
Hazardous
Polymerization: None will occur.
Section VII Spill or Leak
Procedures
Spill, Leak, or Release: Contain spill
and salvage as much material as possible. Pick up the
remaining with absorbent.
Waste Disposal: Dispose of only by
methods approved by and used in accordance with local, state,
and federal regulations.
Section VIII Special Protection
Information
Respiratory:
None required with normal ventilation.
Protective
Gloves: Use rubber or plastic gloves to prevent prolonged
contact.
Eye: Use safety
eye wear where splashing is likely.
Protective
Clothing: None required.
Safety
Precautions: Avoid excessive contact with eyes, skin, and
clothing. Wash hands
thoroughly after handling, especially
prior to eating, drinking, or smoking.
Section IX Special Precautions
Storage: Do not store above 1200F or under 350F.
Freezing may damage the emulsion. Keep container tightly
closed to prevent leakage or evaporation. Keep out of reach
of children.
Section X
Regulatory Information
EPA Regulations:
SARA Section 311/312 Hazards Categories: None
DOT Shipping
Name: Not Regulated.
Disclaimer:
As the handling and use of products under user’s conditions
are beyond our control, no warranty, expressed or implied,
including, but not limited to merchantability or fitness for a
particular use, is made concerning this product. The user
assumes all risk of use or handling whether or not in
accordance with any directions or suggestions of the
supplier. Seller shall not be liable to purchaser or any
other person for loss or damages directly or indirectly
arising from the use of our products, from breach of any
warranty or from any other cause, the exclusive remedy against
the seller being to require replacement or repair of defective
goods.
|
